The Great Ball Contraption Wiki
avatar 141.101.105.131

The Akiyuki Project

From The Great Ball Contraption Wiki

The Akiyuki Project is a thread on Eurobricks with "the goal of creating and/or finding complete...instructions" for the GBC modules created by Kawaguchi Akiyuki.

This article organizes the results of that collaboration for easy reference.

Two1x1plates.png
This article or section is incomplete.
Please improve the article, or discuss the issue on the talk page.

Catch and Release[edit]

Catch and Release

Size[edit]

The version below contains 717 parts. This is one of the smallest Akiyuki modules, costing less than 100 USD to build.

Models and Instructions[edit]

Adjusting and Timing[edit]

  • The model is somewhat sensitive to the rubber bands that are used. Blakbird used a doubled up blue band and found that it was too tight so the downward force was not enough to force the jaws open. He used a small white band looped over only two of the three fingers instead. The module works very well once adjusted.
  • There is no timing to set on this module.

Credits[edit]

  • jesuskyr did the builk of work the reverse engineering the module and creating the LDraw model and instructions.
  • Blakbird tested and tuned the replica. <--- like a category --->